Please Take Over This Page and Apply to be Editor-In-Chief for this topic: There can be one or more than one Editor-In-Chief. You may also apply to be an Associate Editor-In-Chief of one of the subtopics below. Please mail us  to indicate your interest in serving either as an Editor-In-Chief of the entire topic or as an Associate Editor-In-Chief for a subtopic. Please be sure to attach your CV and or biographical sketch.
In classical electromagnetism, the polarization density (or electric polarization, or simply polarization) is the vector field that expresses the density of permanent or induced electric dipole moments in a dielectric material. The polarization vector P is defined as the dipole moment per unit volume. The SI unit of measure is coulombs per square metre.
Polarization density in Maxwell's equations
The behavior of electric fields (E, D),magnetic fields (B, H), charge density (ρ) and current density (J) are described by Maxwell's equations. The role of the polarization density P is described below.
Relations between E, D and P
which is convenient for various calculations.
A relation between P and E exists in many materials, as described later in the article.
so that the total charge density that enters Maxwell's equations is given by
where ρf is the free charge density (describing charges brought from outside).
At the surface of the polarized material, the bound charge appears as a surface charge density
where is the normal vector. If P is uniform inside the material, this surface charge is the only bound charge.
When the polarization density changes with time, the time-dependent bound-charge density creates a current density of
so that the total current density that enters Maxwell's equations is given by
where Jf is the free-charge current density, and the second term is a contribution from the magnetization (when it exists).
Relation between P and E in various materials
In a homogeneous linear and isotropic dielectric medium, the polarization is aligned with and proportional to the electric field E. In an anisotropic material, the polarization and the field are not necessarily in the same direction. Then, the ith component of the polarization is related to the jth component of the electric field according to:
As in most electromagnetism, this relation deals with macroscopic averages of the fields and dipole density, so that one has a continuum approximation of the dielectric materials that neglects atomic-scale behaviors. The polarizability of individual particles in the medium can be related to the average susceptibility and polarization density by the Clausius-Mossotti relation.
In general, the susceptibility is a function of the frequency ω of the applied field. When the field is an arbitrary function of time t, the polarization is a convolution of the Fourier transform of χ(ω) with the E(t). This reflects the fact that the dipoles in the material cannot respond instantaneously to the applied field, and causality considerations lead to the Kramers–Kronig relations.
If the polarization P is not linearly proportional to the electric field E, the medium is termed nonlinear and is described by the field of nonlinear optics. To a good approximation (for sufficiently weak fields, assuming no permanent dipole moments are present), P is usually given by a Taylor series in E whose coefficients are the nonlinear susceptibilities:
References and notes