Silicosis primary prevention

Jump to navigation Jump to search

Silicosis Microchapters

Home

Patient Information

Overview

Historical Perspective

Classification

Pathophysiology

Causes

Differentiating Silicosis from other Diseases

Epidemiology and Demographics

Risk Factors

Screening

Natural History, Complications and Prognosis

Diagnosis

Diagnostic Criteria

History and Symptoms

Physical Examination

Laboratory Findings

Chest X Ray

CT

MRI

Other Imaging Findings

Other Diagnostic Studies

Treatment

Medical Therapy

Surgery

Primary Prevention

Secondary Prevention

Cost-Effectiveness of Therapy

Future or Investigational Therapies

Case Studies

Case #1

Silicosis primary prevention On the Web

Most recent articles

Most cited articles

Review articles

CME Programs

Powerpoint slides

Images

American Roentgen Ray Society Images of Silicosis primary prevention

All Images
X-rays
Echo & Ultrasound
CT Images
MRI

Ongoing Trials at Clinical Trials.gov

US National Guidelines Clearinghouse

NICE Guidance

FDA on Silicosis primary prevention

CDC on Silicosis primary prevention

Silicosis primary prevention in the news

Blogs on Silicosis primary prevention

Directions to Hospitals Treating Silicosis

Risk calculators and risk factors for Silicosis primary prevention

Editor-In-Chief: C. Michael Gibson, M.S., M.D. [1]

Overview

Silicosis is a preventable disease. The Occupational Safety and Health Administration (OSHA) has set a permissible exposure limit for respirable silica of 10 mg/m3. The National Institute for Occupational Safety and Health (NIOSH) standard is a more stringent exposure limit of 0.05 mg/m3

Primary Prevention

  • Prevention of silicosis is by identification of work-place activities with high concentrations of crystalline silica dust and elimination/control of the exposure.

NIOSH Recommended Exposure Limit (REL): NIOSH recommends that employers control exposure to respirable crystalline silica so that no worker is exposed to a time-weighted average concentration of silica greater than 50 µg/m3 of air, as determined by a full-shift sample for up to a 10-hour workday of a 40‑hour workweek OSHA Permissible Exposure Limit (PEL): The OSHA general industry PEL for quartz, the most common form of crystalline silica, is an 8-hour time-weighted average exposure to respirable dust. For pure quartz silica, the PEL is approximately equal to 100 µg/m3 of air

  • Health monitoring of workers with exposure to respirable crystalline quartz using chest radiographs and spirometry may assist in the early diagnosis and management.
  • Measures employed to limit the exposure to crystalline silica [1] :
  • Employers should provide appropriate controls for crystalline silica-containing dust.
  • Use all available engineering controls such as blasting cabinets, water sprays, and local exhaust ventilation.
  • Use less hazardous materials if available and can be used.
  • Be aware of the health effects of crystalline silica and that smoking adds to the damage.
  • Know about work operations where exposure to crystalline silica may occur.
  • Participate in any air monitoring or training programs offered by the employer.
  • Use type CE positive pressure abrasive blasting respirators for sandblasting.
  • Use unaltered respirators when required for protection against crystalline silica-containing dust. Workers who use tight-fitting respirators cannot have beards/mustaches which interfere with the respirator seal to the face.
  • Allocation of specific disposable or washable work clothes at the worksite; showerin and changing into clean clothing before leaving the worksite.
  • Do not eat, drink, use tobacco products, or apply cosmetics in areas where there is dust containing crystalline silica.
  • Wash hands and face before eating, drinking, smoking, or applying cosmetics outside of the exposure area.

References

  1. "Worker Exposure to Silica during Countertop Manufacturing, Finishing and Installation" (PDF).

Template:WH Template:WS