Silicosis primary prevention

Silicosis Microchapters
Home
Patient Information
Overview
Historical Perspective
Classification
Pathophysiology
Causes
Differentiating Silicosis from other Diseases
Epidemiology and Demographics
Risk Factors
Screening
Natural History, Complications and Prognosis
Diagnosis
Diagnostic Criteria
History and Symptoms
Physical Examination
Laboratory Findings
Chest X Ray
CT
MRI
Other Imaging Findings
Other Diagnostic Studies
Treatment
Medical Therapy
Surgery
Primary Prevention
Secondary Prevention
Cost-Effectiveness of Therapy
Future or Investigational Therapies
Case Studies
Case #1
Silicosis primary prevention On the Web
Most recent articles
Most cited articles
Review articles
CME Programs
Powerpoint slides
Images
American Roentgen Ray Society Images of Silicosis primary prevention All Images X-rays Echo & Ultrasound CT Images MRI
Ongoing Trials at Clinical Trials.gov
US National Guidelines Clearinghouse
NICE Guidance
FDA on Silicosis primary prevention
CDC on Silicosis primary prevention
Silicosis primary prevention in the news
Blogs on Silicosis primary prevention
Directions to Hospitals Treating Silicosis
Risk calculators and risk factors for Silicosis primary prevention

Editor-In-Chief: C. Michael Gibson, M.S., M.D. [1]

Overview

Silicosis is a preventable disease. The Occupational Safety and Health Administration (OSHA) has set a permissible exposure limit for respirable silica of 10 mg/m3. The National Institute for Occupational Safety and Health (NIOSH) standard is a more stringent exposure limit of 0.05 mg/m3

Primary Prevention

• The best way to prevent silicosis is to identify work-place activities with crystalline silica dust and then to eliminate or control the exposure.

NIOSH Recommended Exposure Limit (REL): NIOSH recommends that employers control exposure to respirable crystalline silica so that no worker is exposed to a time-weighted average concentration of silica greater than 50 µg/m3 of air, as determined by a full-shift sample for up to a 10-hour workday of a 40‑hour workweek OSHA Permissible Exposure Limit (PEL): The OSHA general industry PEL for quartz, the most common form of crystalline silica, is an 8-hour time-weighted average exposure to respirable dust. For pure quartz silica, the PEL is approximately equal to 100 µg/m3 of air

• Measures employed to limit the exposure to crystalline silica :

• Employers are required to provide and assure the use of appropriate controls for crystalline silica-containing dust.
• Be sure to use all available engineering controls such as blasting cabinets, water sprays, and local exhaust ventilation.
• Substitution of less hazardous materials can also be used. ●
• Be aware of the health effects of crystalline silica and that smoking adds to the damage. ●
• Know the work operations where exposure to crystalline silica may occur. ●
• Participate in any air monitoring or training programs offered by the employer. ●
• Use type CE positive pressure abrasive blasting respirators for sandblasting. ●
• For other operations where respirators maybe required, wear a respirator approved for protection against crystalline silica-containing dust. Do not alter the respirator in any way. :*Workers who use tight-fitting respirators cannot have beards/mustaches which interfere with the respirator seal to the face. ●
• If possible, change into disposable or washable work clothes at the worksite; shower and change into clean clothing before leaving the worksite. ●
• Do not eat, drink, use tobacco products, or apply cosmetics in areas where there is dust containing crystalline silica. ●
• Wash hands and face before eating, drinking, smoking, or applying cosmetics outside of the exposure area.

• Health monitoring of workers with exposure to respirable crystalline quartz using chest radiographs and spirometry may assist in the early identification of people developing disease from their exposures.