Shear modulus

Please Take Over This Page and Apply to be Editor-In-Chief for this topic: There can be one or more than one Editor-In-Chief. You may also apply to be an Associate Editor-In-Chief of one of the subtopics below. Please mail us [1] to indicate your interest in serving either as an Editor-In-Chief of the entire topic or as an Associate Editor-In-Chief for a subtopic. Please be sure to attach your CV and or biographical sketch.

File:Shear scherung.jpg

Shear strain

In materials science, shear modulus or modulus of rigidity, denoted by G, or sometimes S or μ, is defined as the ratio of shear stress to the shear strain:

<math>G \ \stackrel{\mathrm{def}}{=}\ \frac {\sigma} {\tau} = \frac{F/A}{\Delta x/h} = \frac{F h}{\Delta x A}</math>

where

<math>\sigma = F/A \,</math> = shear stress;

<math>F</math> is the force which acts

<math>A</math> is the area on which the force acts

<math>\tau = \Delta x/h \,</math> = shear strain;

<math>\Delta x</math> is the transverse displacement

<math>h</math> is the initial length

Shear modulus is usually measured in GPa (gigapascals) or ksi (thousands of pounds per square inch).

Material	Typical values for shear modulus (GPa) (at room temperature)
Diamond	478.
Steel	79.3
Copper	63.4
Titanium	41.4
Glass	26.2
Aluminium	25.5
Polyethylene	0.117
Rubber	0.0006

Explanation

The shear modulus is one of several quantities for measuring the strength of materials. All of them arise in the generalized Hooke's law:

• Young's modulus describes the material's response to linear strain (like pulling on the ends of a wire),
• the bulk modulus describes the material's response to uniform pressure, and
• the shear modulus describes the material's response to shearing strains.

The shear modulus is concerned with the deformation of a solid when it experiences a force parallel to one of its surfaces while its opposite face experiences an opposing force (such as friction). In the case of an object that's shaped like a rectangular prism, it will deform into a parallelepiped. Anisotropic materials such as wood and paper exhibit differing material response to stress or strain when tested in different directions. In this case, when the deformation is small enough so that the deformation is linear, the elastic moduli, including the shear modulus, will then be a tensor, rather than a single scalar value.

File:SpiderGraph ShearModulus.GIF

Influences of selected glass component additions on the shear modulus of a specific base glass.

Sound waves

In homogeneous and isotropic solids, there are two kinds of sound waves, pressure waves and shear waves. The speed of sound for shear waves, <math>v_s</math> is controlled by the shear modulus,

<math>v_s = \sqrt{\frac {G} {\rho} }</math>

where

G is the shear modulus

<math>\rho</math> is the solid's density.

See also

• Shear stress
• Shear strain
• Shear strength
• Dynamic modulus
• Hooke's law
• Impulse excitation technique